I have the BoatSafe 750 installed on the genny platform and it's hardwired to the main switch panel in the cabin. It has its own 15A breaker, where I had a blank for the Galley Stove, since my stove is butane. I also have a remote temp in the bilge, so I can check the min/max when I visit the...
Good to know the 3 hour estimate sounds about right...I'll install it on the genny platorm as well, so it spreads the heat out from the center...did not know I needed to remove interior panels...good to know and thanks... the BoatSafe will be great when I leave the boat at the yard to get the...
Dave,
The dealer estimated at best it would take 3 hours ($118 rate per hour) to install my BoatSafe heater wired to my switch panel, where I have an empty slot label of Stove (my Stove is butane). This sounds very expensive and would think it would take only an hour at most. I think I can do...
Hi Dave - I do plan to keep my boat in the water during this winter and wanted to know what size Boat Safe Heater you purchased? I plan to buy it this week and have the local Sea Ray dealer install it while my boat is in for some DTS recall work. Thanks!
It's the Marina for me...about a mile from my Home. Freshwater and covered...good docks and good friends helping each other. Just a lock away from the Sound...
Todd - Looks like this will be OK for Canada as well, according to the FAQ on the BoatUS website: http://www.boatus.com/mmsi/MM1.htm#q14
"I am a recreational boater in the United States but regularly go into Canadian waters. Can I still use the BoatUS MMSI?
While Canada is considered...
Todd - Nothing planned for this fall, but that could change...Looking forward to the Jan 2010 boat show to check out some GPS setup first... I did notice on this BoatUS website that the registration does not include international, as I do plan to go up to Canadain waters in the future.
Should...
Todd - I have the Northstar NS100 that came with the boat and it is DSC capable. Reading the manual, it seems very easy to setup and use... I plan to get my MMSI and connect the unit to my yet-to-be-purchased GPS before I head into the San Juan Islands and beyond next year..I will do it mainly...
Well, I have been enjoying this thread and just joined the club! I keep my boat moored in a local fresh water covered marina, so I can take the kids out tubing on the lake or slip thru the locks for a cruise in the Puget Sound and ports beyond... My first boat, but grew up around power and sail...