Yesterday I ordered the isolators but the hardware was on backorder from the distributor. After reading this I ordered the rail assembly for each side that comes with all the hardware and isolator excluding the center capscrew and nut. That is available next week. I have talked to two marinas...
Sorry to jump in on the thread. My isolators are gone after 20 years also but not as bad as the pictures in this thread. My 7.6 in my 2000 Sundancer rattles on start and shutdown. I agree there is not much room to lift the Genny but the suggestions with the 2x4 will help.
I am presently on a...
Finally I found the issue with the wiring. The wirebundle has the two power supplies going to the start switches and these were reversed. These wires are in a Main wire bundle and exit the wire bundle to mate with the corresponding switch. I needed to remove the wires from the bundle and...
Update: On the back of the start switch, there are 4 spade connectors. The top 2 are for power in, one is 12v DC and the other is from the crossover switch between the 2 start switches and also supplies 12v DC. They are also linked together within the switch. The 12V source is from the...
Thanks for the reply ZZ13.
I have power at all gauges and if I swap any power connection on the start switch left to right. The fuel solenoids are not powered unless I have both ign switches on at the same time. So I put these back to the original location.
I started with power to all gauges...
Good morning Divwill. Yes that may be what I do until I find where in the line, the connections are swapped. I will need to make up two extension wires as the factory ones are cut to length.
These gauges must pickup the volt reading somewhere in the system. I thought it was at the main...
I may need to clarify...the volt gauge are as if they were on the wrong side. The wiring or indication to the DC panel below deck is reading correctly...start the left, the draw is off the left bank...but if you put both engines to the first click (ACC), the right volt gauge shows the draw when...
I know this sounds simple to fix but I want to do it right.
2000 Searay 410 Sundancer
3116T Cats
I am the second owner and have had this boat for 9 years.
I was troubleshooting housebank poor performance or I may not have noticed this.
When I start my left engine, the left batteries...
Its been awhile since I have been on here but I buy PetroCan Duron SAE 40. I get the Cat SOS kit every year. This year for some reason, most of the oil companies changed their process which spiked the Magnesium count. I called Toromont Cat and they told me the high readings are across the...