Recent content by Cuins

  1. C

    Official 280 Sundancer Thread

    I know a lot has been written about running a remote wire from the helm to the radio via the engine room. Has anyone ever tried running from the helm and around or over the rear berth into the mirrored cabinet to the radio? Thanks 2002 280DA
  2. C

    Official 280 Sundancer Thread

    It's pretty cool that the 280 thread is still going, but as expected the posts are slowing down as this vintage of boat ages. These 369 pages contain almost everything you need to know about the 280 Sundancer and then some. Wouldn't it be great if somehow it could be made into a reference...
  3. C

    Bought a 2001 280 Dancer

    Congrats, we've had a 2003 280 Dancer for about five years and its the best boat we ever owned. Be sure and check out the Official 280 Sundancer Forum. It pages and pages of the best information you can get about your new ride.
  4. C

    Official 280 Sundancer Thread

    I didn't the tech did as it was a little above my knowledge bank. Sensor was cracked and shorting so he was getting a voltage drop at other sensors. They were searching for a fuel issue even though vessel view was showing a voltage issue. I'll start with what VV shows me from now on .
  5. C

    Official 280 Sundancer Thread

    I really like this install as I saw it when you posted before. How did you run the cable from there to the radio? I have a hole in the dash for the current control and need to run the cable to the radio. Thinking that there must be someway without dropping the headliner.
  6. C

    Official 280 Sundancer Thread

    Does anyone know the routing from the dash to the radio. I want to install a new control for the radio in the cabin at the helm? Thanks
  7. C

    Official 280 Sundancer Thread

    I recently had an issue that all should be aware of. 2003 280 Sundancer, single 496, smartcraft but pre smartcraft gauges. Boat started shutting down shortly after start up, would restart and shut down again, then restart and run fine. This went on for about three weeks until Saturday of...
  8. C

    Official 280 Sundancer Thread

    Thank you that route may work.
  9. C

    Official 280 Sundancer Thread

    Changed my navigation lights to the marinebeam LED's. I get an audible click in the engine room and the green lights on the switch pads dim when I turn them on. Is this something I need to be concerned about? Thanks
  10. C

    Official 280 Sundancer Thread

    How did you run the new 8 wire to the radio? I am going to try to go from the helm to the radio in the cabin.
  11. C

    Official 280 Sundancer Thread

    There should be a 12 volt outlet behind the TV also.
  12. C

    Official 280 Sundancer Thread

    I'm out of town until tonight and will send more info over the weekend. Look at your out drive and see if the smartcraft label is there. I have a bravo III. You won't get all the info as you dont have all the sensors. I will try and send a screen shot.
  13. C

    Official 280 Sundancer Thread

    That is exactly what it does, transmits lat/lon for DSC, two wires + and -.
  14. C

    Official 280 Sundancer Thread

    Thanks Captn TJ, I just figured it out when you prompted me to look for a manual. On the 215 it accepts NMEA 0183. Different than the 210, old tech however, they do make a 0183 to 2000 converter.
  15. C

    Official 280 Sundancer Thread

    They were labled NMEA + and -.
Back
Top