Hello All,
Attempted to template for Corinthian Aquamat on bridge of our 2007 44 Sedan Bridge. Could not remove seats so had to work around with my template. Now I am not comfortable that template is any good because all the messing around I had to do.
I think I want to remove helm seats to...
I agree if I do it right drainage should not be an issue. The vents are off boat so they will get a new fresh rebedding all the away around. Thanks for the help.
Sorry for all the questions but did you actually remove your vents or just seal top from outside? I have removed my vents. Can't figure if I want to seal all the way around or leave bottom without sealant to drain water. I am leaning seal all the way around.
Exactly my issue. When I rinse boat or it rains the water funnels off deck and over and behind rear of vent. The water ends up getting behind vent and flowing into my forward engine room bilge. So no issues for you since rebedding?
I hope I am in right place. Recently bought a 2007 44 Sedan Bridge. On trip north ran into some good chop and was taking spray over bow for a while. After that I noticed water coming inside from front windshield that ran a along flat area above guest cabin and a bid down door frame of master...