Recent content by Chung

  1. C

    Cabinet push pull knobs

    Rockler or similar woodworking supplier
  2. C

    Instrument panel removal 40DB

    Does the fly bridge engine instrument panel just pop off? Can't find any fasteners? Thanks.
  3. C

    40 sedan bridge forum

    How do you remove the instrument panel on the bridge? It looks like it might just snap out, but I don't want to force it. Thanks.
  4. C

    40 sedan bridge forum

    Mine came with the boat. Vetus 80 kgf I use it all the time. It has it's own batteries and charger. 24v, two twelves in series. They are sort of in the way between the two engines
  5. C

    Anchor not holding - TOO much chain, anchor type?

    I read somewhere that you have to let a delta set a little longer before you back down on it. Put out more scope. I switched to 150' of chain and 100' ferr of line.
  6. C

    2003 40 sedan bridge

    Hull moisture content below the waterline for sure. Everything else is just standard stuff. Good luck.
  7. C

    Where to clip zinc guppy?

    400 DB 2002 Because of the condition of my zincs when I was hauled last year , I want to hang a zinc over the side. Where can I attach it where it will pick up the ground? Thanks
  8. C

    Crazy Fresh Water system Problem

    Hey you wizards, it was the relief valve and it was plumbed overboard. Thank you, thank you. what a great club this is! It was buried just behind the big exhaust hose and I couldn't see it. Unfortunately, now it won't stop dripping into the bilge. I'll have to replace it, but that's no big...
  9. C

    Crazy Fresh Water system Problem

    On second thought, the pressure relief could be plumbed directly out. I'll check it. Thanks.:smt038
  10. C

    Crazy Fresh Water system Problem

    The hot water heater is easy to see, and I don't think it is the problem. Nothing is going into the bilge Thanks..
  11. C

    Crazy Fresh Water system Problem

    Hello, Getting the boat ready for the season. I'm trying to commission the fresh water system. :smt021 The pumps will never prime. There seems to be a direct leak to an overboard discharge. At first I thought it was a leak into the bilge and a bilge pump was going on. But it is not a bilge...
  12. C

    Seem to have lost 110V on the port side.

    Is there another fuse or breaker somewhere other the than the main panel? Nothing on my Port side (110V AC) is working.
  13. C

    Important question about running on one engine

    Last year I had the oil pressure go to zero on my port engine. I shut it down . I was about 10 miles from home and ran at about 6 knots. It was the gauge of course. I didn't think about the shaft cooling issue, but I have not seen any problems to date. The auto pilot handled the steering.
  14. C

    400 DB Davits?

    Thanks guys, I have one similar to Dancing Angels'. Problem is that it can accumulate water at certain lower speeds from the wake. Do you have that problem? The NJ ones look very nice. Do you have some pics? I am curious as to the installation - where does the cable post go?
  15. C

    400 DB Davits?

    Hi, I'm curious as to what you are using for davits.
Back
Top