Recent content by Chris-380

Might be able to take it to a motor shop that rewinds starters and alternators and have them go through it

My experience is windless work til they don’t. You won’t hurt the new windless (imo) reusing the old rode. Is the old one rotating slower than it used to, or is it slipping on the old rode?

Tabs, full water tank, and chain rode helps get the nose down

Looks great, Thank you for sharing!

Thank you! It’s def a lot of up and down, and I was super sore for a day after each day I worked on it. But it’s not as bad as I feared it would be

Bump Kind of surprised not many have tackled this project

Screws, stainless, magnet does nothing, it’s a pita, feel around with a screw driver. They start about an inch off the end, about center or a little down floor to ceiling wise I used a thin putty knife behind it to locate the screw…

Who has changed their carpet out on the walls and baseboard. Any pics and advice is greatly appreciated Here is some pics of the flooring I am installing, once complete I want to change the carpeted area out

So happy to see these videos. I watched all of them. Onward and upward! Can’t wait to see the next videos

Starting to come together. Cut the openings for the hatches this morning. Put a couple pieces of the carpeted trim back on and cleaned up a mess. The router was great for cutting the openings, but made a mess Now to start building the hatches….

That is different than my bulbs Mine were G4 like @Skybolt shared Letaclanic G4 LED Light Bulbs 3000K Warm White Lighting Dimmable, 3W Equivalent to 30W AC DC 12V-24V, Bi-pin LED Bulb Silicone G4 LED Bulbs (10-Pack) https://a.co/d/5bkK8Iq

Should fit, the only issue for my boat would be it looks like the salon has a fixed table

Originally, I changed the bulbs, 3 years later I changed the whole fixture I used the ones you shared in the bathroom, but these in the rest of the salon. They are about 1/2” bigger, so I used a dremmel tool to make them work…. Look great, cabin looks like a different boat. I think it took...

Can you use an ez out to get the screw removed? Iirc, is this the right latch https://www.go2marine.com/Bomar-Dog-Latch-for-Classic-Series-Portlight-S616

Pull your microwave, on my 380 it’s there iirc