Recent content by chaslanier

Has anyone replaced the corian countertops in the cockpit of a 320? What's invloved? How do you remove the existing corian? Thanks!

Thanks! My is flush mounted also.

How do you get to the light bulb in the recessed light in the cabin above the cooktop? Does the frame screw off or does it pull off? Thanks!

One of my overhead lights in the cabin of our 320 Sundancer has burned out and needs to be replaced. Does anyone know how to replace this? Does the light cover just unscrew?

I haven't since purchasing the boat in 2016. The motors were rebuilt and prior to me purchasing it. It also appears that the risers and manifolds were replaced then.

What would be a normal compression range for Mag 350's? Mine on boat motors are all over the board. Port 1- 140, 2-150, 3-110, 4-110, 5-120, 6-120, 7-130, 8-145 Starboard 1-150, 2-140, 3-120, 4-120, 5-110, 6-100, 7-150, 8-140 Any thoughts! Suggestions? Recommendations?

Thanks! I have V drives. We'll find out soon what the issue is. It is being pulled out of the water this week.

"Throwing a crank bearing", was my description. Probably a bad chose of terminology. Mechanic was on the vessel with me and we both heard it.

Cold start heard clicking from starboard motor. Pressure is fluctuating around 34 to 44 Not staying consistent like port at 43. Mechanic thinks it is about to throw a crank bearing.

What should the oil pressure be for 350Mag on a 320 Sundancer at idle?

Thanks!

Good water flow. Temp around 170. Thanks!

Got this code today.Blk PSI Ckt Lo Starboard Engine. Any ideas?

Thanks! Will try this. Port works fine. You are so right about the documentation not being the greatest.

No. So check the easy link setting in VV?