Recent content by carboncow

Purchased!

Not having much luck. Any idea what they are called or do you have a reference in your account order history. I would appreciate any help!

These are falling apart internally and externally. Can we source these and if not anyone got a good sub. Got two on our 89 340SD. Kind of like them now that we have LED in them. Photo: https://www.dropbox.com/s/3qix5yio26i41t9/Image-1.jpg?dl=0

I had a extra in my garage too and cannot find it. It may be a 3" and I would use that to replace my kitchen/bathroom vent that seized. Now I may go squirrel cage on that to keep it quiet. These appear to be the highest rated on Amazon, any thoughts on these rule units...

Agreed. The more I read last night based on the size of the bilge it sounds like it needs a higher CFM rating which seems to come with the 4" solutions. Thanks again. Any chance you replaced yours and have a recommendation. Doesn't seem to be much out there about who is any quieter then...

Didn't get notice of your post. I haven't pulled it apart yet...does the job take one of these flangmount jabs units or will a typical 3" $20 inline fit? Curious to why you suggested this one! Thx.

My port blower bearing was screaming this weekend...worried it may seize, trip breaker and then have no blowers. Kid, wife and life me from investigating this afternoon figured you guys would know what size (diameter) of the blower/tube is. 3" or 4" on these models? Thanks!

Thanks for the great intel. For some reason I didn't get a notification you responded. Now I'm going to be kicking myself for that extra 3 inch bilge blower I had laying around the garage from an old project that I may have tossed out...would now have a purpose!

Noticed this spring the bearing whine...might have left it on when I left last week as when I arrived this weekend the 12v switch will not hold if one of the two interior switches are on. Sounds like a shorted/seized motor to me. How is that mounted under there and where? I'm hoping that whole...

OK, we are getting stinky so I want to update the filter but haven't taken the time to remove it from the storage location in the read bed yet. Can someone confirm for me what will fit w/o having to completely redo hoses and attachment systems. Hoping for a simply plug and play solution if...

Thanks for taking the time to comment...many good points but I still need an answer to my question. This happened on a previous boat 10+ years ago and I'm quite sure it's the same issue. Although our water runs under the dock too and it's been warm if you feel the water at the spigot it's very...

1989 340 Sundancer Hello, noting that my cold water when hooked up to shore water is not that cold, luke warm. I'm guessing I'm getting some back mixing from the hot water tank. Any ideas where I'll find the check valve that may be causing this mixing? Haven't popped the hatches yet to look...

Boat new to me last summer, AC running but not compressing. Unit is OEM AIrrr and ancient. Thinking of just putting in new unit rather the Diagnosis and recharge. What do you have as a replacement? 12k, 14k or 15k? Sent from my iPhone using Tapatalk

Yep. I got one. I think it's OEM as its never been used until me! Sent from my iPhone using Tapatalk

Thanks...interesting website. Doesn't appear to have anything for the 340 but I'll inquire directly to them. I'm curious to how anyone's curtains attach and if they have photos. My OEM has no system in place. also I'd be curious to how the 340 Sundancer's OEM curtains for the rear bedroom...