Awesome - thanks for the advice on the 1" screws. I have this fear of drilling in new holes in the bilge are in general
yes, tons of space to work with in the 260 especially without the generator
Hi Everyone.
Has anyone installed a new KUUMA Hot water tank on their 260 dancer ? if so, any good videos or material when it comes to redrilling holes for brackets and also connecting the engine hoses with the proper fittings?
@Lazy Daze i hear you man.
Some of these parts are really hard to find or come across
as an example a walk thru center window ...
mine broke last year in a storm and I called dealers and marine Max’s all up and down the coast with no luck.
Flounder pounder, Great Lakes skipper, Taylor made...
Lazy daze, thanks for replying.
I should have clarified.
I did call and they did not have that specific part.
Ive also tried a Sierra switch, but that didn’t work either
I do not have a specific dealer other than calling a marine max which I also tried mine in Somers Point NJ
was hoping...
@Medic A, not sure if you still have your same boat, but wanted to ask what switch you actually bought off DigiKey ? I also have a non working Engine Hatch Switch with the blue tip light but cannot seem to locate that exact switch on the site.
Any help locating this switch would be greatly...
Hi,
Has anyone done the vinyl Aqua Tread Floor in a sundancer 260 cabin right below the step?
If so, could you share your results and sq ft approx?
Thank you
Matt
Hi,
Has anyone done the vinyl Aqua Tread Floor in a sundancer 260 cabin right below the step?
If so, could you share your results and sq ft approx?
Thank you
Matt
Bobfro,
I'm experiencing this same issue with my 2005 260 dancer and after reading your post, i recall seeing the loop at the top of the bilge area starboard side up near the gunnel
do you have a picture of yours?
Hi, i'm late to this post but would you happen to have any pics of the bow and stern thrusters from your old sundancer? i believe the listing is now off the site