Genuine Mercury Smartcraft DTS 4 Way Junction box. This is a used factory original equipment part, not aftermarket. It also comes with a connector to expand to another junction box and two plugin dust covers.
Asking $45.00 US will ship from Canada
Need Info on Arch Speakers:
I have a 6.5" speaker and a separate 2" tweeter speaker on each side of the arch. I would like to replace them with a single speaker that has tweeter and woofer combined. Has anyone done this and if so, how did you wire the woofer/tweeter combo speaker, and what did...
Hi All:
I had the plastic end of my heater hose (Red Uniflex 1/2" No. SF-858) split when disconnecting for winter storage. I thought I could just buy a new end and cut the old one off but alas, nowhere can I find a tight fitting end to re-insert into the hose end with a 1/2" female swivel...
Has anyone else had sh__ty luck like me with the Jabsco water valve that controls water in and out at the stern hookup to shore water. Every summer I have to replace one or two at $60 a pop. If you even slightly move the hose where it connects in the aft cupboard it blows the gasket inside the...
Here is a copy of the article about vent filter rebuilding:
How to recharge holding tank vent filter -- w/pics
At SRO, several members had talked about refilling their holding tank vent filters. By rebuilding your own filter it will probably save you about $100 bucks...
Windshield Power Vent Window
Looking for a replacement rubber gasket that surrounds this power vent window. Leaks pretty badly and would like to replace. Any ideas of suppliers would be appreciated.
Thanks
Bill
Yes I was able to connect the mobile vessel view to one of the empty ports on the newly installed 6 port junction box. I have twin 350 Mag MPI's. I simply connected the one connection and the information from both engines flows through the entire junction box thus being picked up on the mobile...
Hi Jeff: Mine shows empty until it hits 1/2 Full then the lights come on and work thru 3/4 Full and Full Do Not Use. Every spring before launch and when the holding tank is empty, I use a bucket of hot hot soapy water and pull the gauge from the top of the tank, soak it for an hour or so and...
I have twin 350 Mag MPI's with B3 outdrives. Over the last couple of summers on a couple of occasions when I went to power up to go on plane (which I do slowly, not just full throttle from idle) the engines over revved and I went no where. I immediately pulled the throttles back to idle and...
Does anyone in the Trenton N.J. area recognize this boat. If you do and you know the owner you might like to let him know that I have tried several contacts with the broker it is listed with to get more information on the boat. No response whatsoever. Glad I'm not selling mine with this broker.
Would like some opinions and recommendations on underwater lights for the stern. I don’t want to break the bank but would like something with quality and RGB colours.
Thanks
Has anyone found a galley faucet for updating the standard one supplied. I am especially interested in one that is reasonably priced, functional (hot/cold), and one that the nozzle actually fits over the hole in the lid on the sink.
Any and all suggestions would be most welcome!
Thanks guys!
Yes, I did exactly like you and after configuring myself like a pretzel on the floor in the head, I was able to reach around up behind the bowl portion, while my wife worked the screwdriver on top. Good thing nobody took a picture of the two of us in that position in the head! All...