BillK2632's Recent Activity

  1. BillK2632 posted a new thread.

    A great fall day on LKN

    This is why I like fall boating. The weather on LKN yesterday was crystal clear, 70deg and a light wind. No sweating to death, didn't...

    IMG_1562.JPG

    Forum: General Discussion

    Oct 14, 2018 at 8:59 AM
  2. BillK2632 replied to the thread Oil change before winterizing or in the spring?.

    Even with our mild winters and short layup, I change the engine oil / gear lube in the fall before I put it away. That way it's done,...

    Oct 14, 2018 at 8:46 AM
  3. BillK2632 replied to the thread lower unit.

    Yep, that's an exhaust flapper. Not terribly hard to replace once you disconnect the rubber section connecting the riser to the Y pipe....

    Oct 12, 2018 at 4:40 PM
  4. BillK2632 replied to the thread lower unit.

    Nothing like that in the drive that would just fall out. Could it be remnants of exhaust flappers?

    Oct 12, 2018 at 1:19 PM
  5. BillK2632 replied to the thread Newbie Boat, No Engines, 3 Options..............

    If you are up for a project and just like the boat that much go for it -- I would only replace with twins in the original configuration....

    Oct 12, 2018 at 8:03 AM
  6. BillK2632 replied to the thread alpha 1 gen 2 impeller kit?.

    Mercury/Quicksilver: 47-43026Q06 Sierra: 18-3265 These are the complete kit with everything (wear plate, gaskets, slinger seal) except...

    Oct 10, 2018 at 8:11 AM
  7. BillK2632 replied to the thread How do I go about calibrating the tachometer in my boat?.

    Your 4.3 is pretty basic and other than the TKS (which is a fancy choke system) is not any different than my 1999 4.3. It's carbureted,...

    Oct 10, 2018 at 7:58 AM
  8. BillK2632 replied to the thread replacement cost of Bravo III lower unit?.

    + 1 on the prop and drive removal labor. Neither of those items should take more than 30min for an experienced mechanic. Did you get a...

    Oct 10, 2018 at 7:35 AM
Show Sidebar