I am working on re-bedding some HW items, a couple of pieces not sure of how to remove the drain in the cabin access steps (I have an idea but before I rip a panel off I want to ask) and the windshield.
Also the front hatch looks like it has been sealed previously (aftermarket sealant squeezed...
Anyone know a source for these quickie put up carport trusses? they are 3x3" I think or close to it, I don't want a whole kit I'll make my own legs. Prefer Georgia area.
thanks,
So it came up during lunch time conversation that enough ice melts in the summer time to be able to traverse from eastern Canada to Alaska via the mouth of Hudson Bay and Beaufort Sea and rest of the channels. It became very heated topic I just sat back and thought no way enough hair spray was...
Ok I see it, have to buy from a retailer, $65 from iboats.com
Should I caulk on the top of the aluminum rail? and leave bottom open for drainage? Maybe seal bottom of bow area only? I know it has been questioned here on other posts mostly stated leave bottom with no caulk.
I had one area about...
Oil look normal? have you done a compression and leak down test on cylinders? vacuum check? sparks all look the same? when you do run it and it warms up pull off the valve cover breather smoke coming out? Just some preliminary items to check for general health of the engine...
You need a steam cleaner, not a hot water, not an electric, but a kerosene\diesel heating type. No need for high pressure low throttle will do most of that crud will melt off. Follow up with some elbow action....
Frank,
I understand what you are saying and appreciate you sharing it. I also know that SR (others also) decks are cored and transoms have a sheet of plywood in them. Just my preference to have least amount of cored structure. I had read previously and can't find it that Brunswick...