Recent content by Alum of CU

  1. Alum of CU

    500/520 DB official thread

    I would just pull the switch out and look at the part number. It's probably a very common item on internet.
  2. Alum of CU

    How I fixed my cycling Vacu flush

    Also, for those of you watching this thread, don't ever disassemble that sprint cartridge. Mine was an older model and while I got it back together, it was quite difficult.
  3. Alum of CU

    How I fixed my cycling Vacu flush

    I had to cut an access panel in my crew head to fix that pump and hose fittings there was no other way to get to it. removed tile, cut access, retiled with updated look.
  4. Alum of CU

    How I fixed my cycling Vacu flush

    I had a leak in one of mine (real nasty due to clamp fail) but ended up doing both pumps. I took them out, soaked in sew clean, put back together with same parts. All duckbills replaced, but yes, there was an additional one coming off the captains head. So I just picked the best of the 5 that...
  5. Alum of CU

    Raypilot 650 Manual

    I have the factory owners manual for the RayPilot 650 if anyone wants it. In very good condition. I guess the previous owner put in a new autopilot in 2006 so this must have been what was in the boat.
  6. Alum of CU

    Wanted Raymarine

    have the factory owners manual for the RayPilot 650 if anyone wants it. In very good condition. I guess the previous owner put in a new autopilot in 2006 so this must have been what was in the boat.
  7. Alum of CU

    Raymarine Electronics For Sale

    I have the factory owners manual for the RayPilot 650 if anyone wants it. In very good condition. I guess the previous owner put in a new autopilot in 2006 so this must have been what was in the boat.
  8. Alum of CU

    Official 510 DA Owners Group

    Stephen, while 2 years late I didn’t see any replies. There is a knob on your dash that only works when the nav lights are turned on. Hopefully this helps.
  9. Alum of CU

    Vacuflush toilet cycles every 2 to 3 hours - 1998 Sundancer 290

    If you’ve replaced the seal, Remove the valve body on side, and clean that plunger. Also, clean the screen located in the housing. I just both of mine this week and they had chunks of calcium deposits. Max flow now on flushes. You can lube the spring cartridge through a couple of holes. Do not...
  10. Alum of CU

    Vacuflush toilet cycles every 2 to 3 hours - 1998 Sundancer 290

    This is normal per owners manual. Every 3-4 hours or more it will cycle on.
  11. Alum of CU

    Wiper Fluid motor and squirter access

    Update: I didn’t need to ream holes. Access to port squirter above speaker box port side (removed speaker cover with blunt kitchen knife), center squirter behind panel (center dash, easy access), STBD unfortunately needed to take some staples out of headliner. Squirter is just forward of stbd...
  12. Alum of CU

    Official 510 DA Owners Group

    For fender storage I put holders on inside bow railing. Size fender is HTM-3
  13. Alum of CU

    Official 510 DA Owners Group

    There is a connection at the front of the engine. Make sure that isn’t boogeredup as well. On mine, the waterproof gasket had slipped and was interfering with the pin. It’s just a little 4 pin connector, probably right near top transmission Can you take the cluster apart and replace just the gauge?
Back
Top