Separate names with a comma.
The fridge opening isn’t the only consideration on this boat.
Ensure whatever you buy fits through the cabin door! It’s not square and rather...
With the amount of spray you're going to see on the platform, I'd think 316 Stainless would be a better choice.
Also from a strength point of...
I may have a replacement cable for sale if you don't have luck splicing, PM ME.
4K puts a 6ft platform from Swimplatforms.com on the back.
They look and fit great.
The water tank is in the transom, though it can be pulled for this sort of work. You'd have to remove the aft berth, night table and rear state...
I may have one that I'd be willing to sell cheap. PM me the Sea Ray part number and I'll let you know.
There aren't many PWC's that weight less than 750 these days.
Im sure a Seadoo Spark would be OK, but nothing heavier.
FYI, you're a little over propped. The fuel curve for the 450c has it at 13.6 GPH @ 2200.
You should be able to select your currency on their website.
Also you may not have to pay VAT.
I would avoid a Magic Eraser, they are abrasive and remove material to clean.
Many have success with Spray 9, others say try a diluted bleach...
Try adding wolverine oil pan heaters and/or CAT block heaters. They are less smokey when preheated.
On mine that's a platform (plywood, suspended between the stringers). It sits on top of the black water tank.
I can't think of a void in the front of the engine room? Unless he's talking about the voids under the genset and vacufluah I'm stumped!
On mine water actually ran down the rear and INTO the scuppers.
I pulled the aft seats and sealed the scuppers. The rear door is well...
I assumed that void was foam filled. Can anyone confirm what's actually in there?
I'd always assumed the stern high attitude of the boat was...