Recent content by 1ky

The manifold was replaced in 2014 because of bad winterization. The boat sat for the next 5 years with minimal use. The previous owner lost interest. Now I’m chasing gremlins.

After no luck with a couple compression tools to remove the line I decided to take the 3 line manifold loose to make it easier access. Finally it releases! The manifold comes apart in sections so that other lines can be added. The first (right) section supplies the galley with hot water. Always...

I’m going to Lowes today anyway. Thanks

If I were 30 lbs lighter and 20 years younger this wouldn’t be a hard task at all but..... All good information guys. I’m going down to the boat Friday to change the oil and get this manifold thing resolved before winterization. Thanks so much for taking the time to reply.

The center hot water line is the one to the head sink The release mechanism was in the down position when I first started this project, yet the line won’t pull out. Also, it’s hard to get in position to get a good bit of lift on it.

I used a shop vac at the sink end pulling and pushing with no result. The manifold valve is hard to turn but it is open. one of the manifolds was replaced before i bought it. Not sure if it was hot or cold. The release mechanism on that line is in the down position but the line wont pull out...

I’m not getting hot water through my line to the head sink. Manifold knob for that line is turned on. I switched the cold over to the hot side to make sure the faucet was okay. Another hot water line from the same manifold to the galley sink is providing hot water just fine. Any way to clean the...

Odd that they only put one but it helps a lot.

I’ll post pictures when they’re installed.

My 340 friends will know exactly what these are and what a difference they make.

Has anyone replaced the bulbs in this type light? I don’t see a brand on them anywhere Thanks

Mark Stonkus (678) 598-0740