480 DB Owners Club

B28DEE01-5B80-4472-A942-513C15EB5FE1.jpeg
Hey Russ,

Would you be able to do some measurements on the position of your overhead box? I have one of them to install into our boat, but havent gotten around to doing it. thinking maybe a quick project to get it done..

thanks in advance,
Don

Don, sorry for the delay and the poor graphics! Let me know if you need any other points measured -
 
Well that sucks... sorry for the confusion.. you did get the cool bottle storage though..
That’s true: another question... any ideas on the replacement if s giod convection microwave that fits into the cabinet. I’m guessing it’d have to vent towards the front due to it being inside a cabinet.
 
I have a sharp Microwave/convection in mine. I think it just slid in, doesn't really vent anywhere that i'm aware.
 
it seems that everyone just replaces their unit with whatever. I'm concerned because convection ovens get hot (very hot) and I worry that, if not vented properly one would run the risk of fire????
 
The OEM ones are made by DeAngelo, my STBD one is off now and being sent back for pressure test and new insulation. Port one was done two years ago. Let me know if you need any more pics. Model # is 14924 I believe.
Hey Quality Time, just as follow-up, thanks for the info the risers, exactly what I needed. Can you or anyone else confirm that on this vintage boat there are 4 duckbill valves on each vacuum tank and 2 on the macerator and the 1 1/2" dometic one will work (or a part number)? Also anybody know the model number on this vintage Reverso system and where one might get just the cover for it?
Also, are your 8" tubes leaving the elbow in the exhaust back to the muffler tanks fiberglass or metal? Thanks
 
Yes, there are (4) 1-1/2” duckbills per vacuum tank and (2) in the macerator pump. Let me know if you need the part #.

The Reverso model # is OP7 - never bought parts for it other than an impeller kit.

My 8” tubes are stainless but some boats had fiberglass. I believe there was a Monel upgrade available at one time.
 
Need to change out my hot water heater pressure relief valve. Atwood could not tell me if it is a 75 or 150 PSI rated. The collar tag is half missing and I can't read anything on it. Anyone able to take a look at what they have? Atwood is telling me it is either 150 or 75 PSI. Thanks, Dave
 
I replaced mine a few years ago. I believe it was a 75 PSI but can check this weekend if you don't get an answer by then.
 
Thanks, Quality Time. Would like to know for sure exactly what I should replace with. Let me know when you have a chance. Don't know if you will be able to see manufacturer and part number. Thank you. Dave
 

Forum statistics

Threads
112,944
Messages
1,422,715
Members
60,927
Latest member
Jaguar65
Back
Top