KevinC
Well-Known Member
Next I started positioning the rocker switch. I thought it was best next to the trim tab switches.
I marked the exterior then offset the cut needed
after cutting the hole this is what the switch will look like mounted
The final mount is completed by drilling some pilot hole and screwing to the console.
This is my HDS-5 installed along with it. If anyone is interested in that install I can post later. It was pretty simple compared to the windlass.
I marked the exterior then offset the cut needed
after cutting the hole this is what the switch will look like mounted
The final mount is completed by drilling some pilot hole and screwing to the console.
This is my HDS-5 installed along with it. If anyone is interested in that install I can post later. It was pretty simple compared to the windlass.