YachtRock
New Member
- Jun 7, 2020
- 2
- Boat Info
- Working on a Sundancer 240
- Engines
- 5.0 Mercruiser Bravo III
Not sure if you can see in the photos, but it even looks like there might be some perforations in the aluminum at the gusset part of at the exit of the housing where the props are. I’m assuming the corrosion looks similar where one can’t see the bearing and seal surfaces. Called around and a housing, bearings, seals and zinc kit is going to be $3500 plus labor. Am I working too much about this corrosion?