Cocktail Time
Well-Known Member
- Jul 9, 2007
- 1,208
- Boat Info
- 1998 400 Sundancer, Garmin 840xs GPS, Furuno Radar, B&G GPS pilot etc.
- Engines
- Cat 3116's, Westerbeke 7.6 BTD
Guys, anyone have a scrap piece of burl wood dash material laying around? I need to make a trim ring to cover where my old Clarion remote was mounted and was thinking a donut shaped hole. Not picky as to the type as this will probably be temporary until I get new dash panels from tecnografic. I've seen a couple installs where folks cut a panel to mount a gps.
Open to ideas on how to better do this, if there is an easier solution than the dash material. I'd prefer not to use starboard. Thanks, Dan
Open to ideas on how to better do this, if there is an easier solution than the dash material. I'd prefer not to use starboard. Thanks, Dan